Ball Python Background #2

 Onto carving! So this was by far the most tedious and time consuming part of the entire process. I had a mini angled hand saw, a carpet cutter, a utility knife, and a scraper.

Cut off the top layer of the foam. Basically any shiny part of the foam needs to be cut off because the silicone won't stick to it.














*Four hours later*

 So, I picked up some caulk and rubber gloves (this stuff will get everywhere I promise) from the hardware store and loaded that in a caulk gun.

Squeeze some caulk in generous amounts and then rub it in every crack and crevice. I'd start at the back because those spots are harder to reach.

Afterwards take a cup full of Zoo Med Eco Earth Coconut Substrate and pour more than you think you will need onto the silicone and let it sit.

In the end, you should end up with something that looks like this!

Make sure you get every part of the foam covered with silicone! I had to go back and redo a couple spots because I missed them.